SIIG Serial ATA PCI RAID Bedienungsanleitung PDF herunterladen (Seite 34)

Installation

3-7

For an existing Windows NT System

1. Before installing the board, boot up Windows NT. Select My

Computer/Control Panel/SCSI Adapters, then click on the

"Drivers" tab.

2. Select Add… then Have Disk....

3. Insert the Software Installation diskette into the floppy drive

and type in A:, then click OK.

4. Highlight CMD PCI-0649 Ultra 100 IDE RAID Controller and

click OK.

5. Remove the Software Installation diskette and select No to

restart NT.

6. Shutdown NT then turn off the computer and install the

RAID controller into a PCI slot.

3-3.5 Verify Proper Installation for NT 4.0

1. Go to My Computer/Control Panel/SCSI Adapters.

2. Highlight CMD PCI-0649 Ultra 100 IDE RAID Controller

from SCSI Adapters listing and select Properties. A

message This device is working properly is displayed in the

dialog box, the driver has been correctly installed.

3-3.6 Windows 2000 Driver Installation

For a new Windows 2000 installation

1. After installing the board, boot up your system.

2. Execute the Windows 2000 installation program.

3. Restart the computer when prompted by Windows' installation.

4. At the Windows 2000 Setup Screen press F6 to install the driver

for the RAID controller.

5. When prompted press S to specify the location of the driver.

6. Insert the driver installation floppy, then press Enter.

7. CMD PCI-0649 Ultra 100 IDE RAID Controller will appear in

the box, press Enter.

8. Press Enter to finish the RAID driver installation, then follow

the onscreen instructions to complete Windows 2000 installation.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Keine Kommentare

SIIG Serial ATA PCI RAID Bedienungsanleitung Seite 34