SIIG Serial ATA PCI RAID Bedienungsanleitung PDF herunterladen (Seite 30)

Installation

3-3

3. Install the hard disk drive to your computer. Attach the end

connector of the Ultra ATA/100 cable to the connector on

the hard disk drive. Make certain that pin 1 on the cable

(indicated by the colored stripe) matches pin 1 on the hard

disk drive’s connector.

Note: The ribbon cable has two connectors. If you have one hard

disk drive, connect it to the end connector of cable (Drive C). If

you have a second hard disk drive, then connect it to the middle

connector of cable (Drive D).

The same procedure applies when making connection to IDE2.

Reconnect the system power and other peripherals to the computer.

You are now ready to install the software drivers.

3-3 Software Installation

This section provides information on how to install the UltraATA

100 PCI RAID drivers for the following operating systems:

New & Existing Windows 98/98SE

New & Existing Windows Me

New & Existing Windows NT 4.0

New & Existing Windows 2000

Figure 3-2: Connecting Internal Drives

IDE1

IDE2

Internal

Drive 1

Internal

Drive 2

(If Any)

UltraATA 100 PCI

Drive C Drive D

End

Connector

Middle

Connector

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

Keine Kommentare

SIIG Serial ATA PCI RAID Bedienungsanleitung Seite 30