SIIG USB Over IP Installationsanleitung PDF herunterladen (Seite 7)

Windows Server 2003 (32-bit)

Windows Firewall/Internet Connection Sharing (ICS)

must be running before installing the USB over IP drivers.

1. Connect the USB over IP to your network.

2. At the Windows desktop insert the driver CD.

3. Autorun should start the installation, if not, click

Start, then Run. Type D:\Launch.exe then click

OK. (Change D: to match your CD-ROM drive letter)

4. At the USB Over IP screen, click Install.

5. At Choose Components, click Next.

6. At Choose Install Location, click Install.

7. At Security Alert, click Yes.

8. Click Yes to add the application to Windows Firewall

exceptions list, then click Finish.

9. At the Found New Hardware Wizard, select No, not

this time, then click Next.

10. Select Install the software automatically

(Recommended), click Next.

11. At Security Alert, click Yes.

12. Click Finish.

13. Repeat steps 9-12 for each USB Over IP connected

that matches your subnet address.

14. Close the USB Over IP screen to complete the

installation.

Windows Server 2008 (32-bit)

Make sure that Windows Firewall is configured before

installing the USB over IP driver.

1. Connect the USB over IP to your network.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

SIIG USB Over IP Installationsanleitung Seite 7