SIIG UltraATA 133 PCI Installationsanleitung PDF herunterladen (Seite 15)

Windows 2000 Driver Installation

For New Windows 2000 Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, follow Microsoft procedures to install Windows

accordingly.

2. At the Windows Set-up screen, press F6 to specify and add

the driver.

3. Insert the Driver diskette. Press S, then press Enter.

4. Select SIIG CN2496 ATA 133 RAID Win2000 Miniport

Driver and press Enter.

5. Press Enter to continue and follow on-screen instructions to

complete installation.

For Existing Windows 2000 Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, boot up Windows.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended) and click Next.

4. Insert the Driver diskette into the floppy drive, check Specify

a location, uncheck the other boxes, click Next, type in

A:\Win2000. Click OK and then Next to continue.

5. If the Digital Signature Not Found message appears, click

Yes.

Note If prompted for Windows 2000 CD-ROM, insert the CD

and click OK. Type in D:\I386, click OK and Finish. (assuming

D: is your CD-ROM drive)

6. Click Finish, remove the Driver diskette and click Yes to

restart Windows to complete driver installation.

Windows XP Driver Installation

For New Windows XP Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, follow Microsoft procedures to install Windows

accordingly.

2. At the Windows Set-up screen, press F6 in order to specify

and add the driver.

1 2 ... 10 11 12 13 14 15 16 17 18

Keine Kommentare

SIIG UltraATA 133 PCI Installationsanleitung Seite 15