SIIG UltraATA 133 PCI Installationsanleitung PDF herunterladen (Seite 12)

Software Installation

This section provides information on how to install the UltraATA 133

PCI RAID drivers for the following operating systems:

New & Existing Windows 98/98 SE

New & Existing Windows ME

New & Existing Windows NT 4.0

New & Existing Windows 2000

New & Existing Windows XP

Windows 98/98SE Driver Installation

For New Windows 98/98 SE Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, follow Microsoft procedures to install Windows

accordingly.

2. Once Windows has been installed, double click My

Computer/Control Panel/System, then click Device Manager.

3. Double click Other Devices then PCI SCSI Bus Controller.

4. Click Driver tab, then Update Driver.

5. Insert the Driver diskette and click Next.

6. Select Search for a better driver than the one ...option and

click Next.

7. Check Specify a location, uncheck the other boxes, type in

A:\Win9x and click Next. Click Next and then Finish.

8. Remove the Driver diskette and click Yes to restart Windows

to complete driver installation.

For Existing Windows 98/98 SE Systems

1. After the UltraATA 133 PCI RAID and attached drives are

configured, boot up Windows.

2. At the Add New Hardware Wizard, click Next.

3. Select Search for the best driver for your device option and

then click Next.

4. Insert the Driver diskette, check Specify a location, uncheck

the other boxes, type in A:\Win9x, and click Next.

5. Click Next and then Finish respectively.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

SIIG UltraATA 133 PCI Installationsanleitung Seite 12