SIIG Serial ATA PCI Installationsanleitung PDF herunterladen (Seite 3)

1. Turn OFF the power to your computer and any

other connected peripheral devices.

2. Unplug the power cord from the back of the

computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

6. Replace the slot bracket's holding screw to secure

the card.

Device Connection

The Serial ATA PCI is a dual channel Serial ATA controller

that supports up to two Serial ATA hard disk drives. If

you plan to use the second Serial ATA channel, you will

need to purchase another Serial ATA cable.

1. Install hard disk drive(s) in chassis.

2. Connect the Serial ATA hard disk drive to the system

power supply using the Serial ATA power cable.

3. Connect one end of the Serial ATA cable to the hard

disk drive.

Figure 2. Hard disk drive connections

4. Attach the other end of the Serial ATA cable to the

Serial ATA connector on the Serial ATA PCI.

Serial ATA cable

Power cable adapter

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

SIIG Serial ATA PCI Installationsanleitung Seite 3