SIIG Serial ATA PCI Installationsanleitung PDF herunterladen (Seite 10)

Note: When the Software Installation warning

pops up, click Yes. And when the Hardware

Installation warning pops up, click Yes again. Our

driver has been thoroughly tested in Windows for stability.

For Existing Windows XP Installation

1. Install the board and boot up Windows XP.

2. At the Found New Hardware Wizard, insert the

driver diskette, select Install the software

automatically (Recommended), then click Next.

3. When a warning message pops up, click Continue

Anyway, then click Finish. Our driver has been

thoroughly tested in Windows for stability.

4. Remove the driver diskette and restart Windows to

complete the driver installation.

Verify Proper Installation for Windows 2000/XP

1. Right click My Computer and click Manage.

2. Select Device Manager.

3. Double click SCSI and RAID Controllers, then

double click Silicon Image SiI 3112 ... Controller to

display driver properties.

4. A message This device is working properly is displayed

in the dialog box, the driver has been correctly

installed.

Bios Configuration

The Serial ATA PCI BIOS will appear everytime your

system starts up. If the bios doesn't show, please try your

controller in another PCI slot. During this (Post) process,

the bios will show up and indicate the devices attached to

it.

1 2 ... 5 6 7 8 9 10 11 12

Keine Kommentare

SIIG Serial ATA PCI Installationsanleitung Seite 10