SIIG SC-UNS012 Installationsanleitung PDF herunterladen (Seite 4)

Connecting Serial ATA drives

The USB 2.0+FireWire+SATA Combo board supports up to two Serial

ATA hard disk drives. If you plan to use the second Serial ATA

channel, you will need to purchase another Serial ATA cable.

1. Install hard disk drive(s) in chassis.

2. Connect the Serial ATA hard disk drive to the system power

supply using the Serial ATA power cable adapter.

3. Connect one end of the Serial ATA cable to the hard disk drive.

4. Attach the other end of the Serial ATA cable to the Serial ATA

connector on the USB 2.0+FireWire+SATA Combo board.

5. Follow the same instructions when connecting a second hard

drive.

Figure 3. Hard disk drive connections

Software Installation

Throughout driver installation, you may be prompted to insert your

Windows Installation CD. Some files on this CD are neccessary to

complete the driver installation. Please insert the CD when

prompted and follow on-screen instructions.

Windows 98SE Driver Installation

1. Boot up Windows. At the Add New Hardware Wizard

window, click Cancel.

Note: Click Cancel 6 times if a hard disk drive is attached.

2. Insert the USB 2.0 driver diskette. Click Start, Run, type in

A:\setup206.exe, then click OK.

3. Choose Yes, I want to restart my computer now, then click

Close. Remove the driver diskette.

Serial ATA cable

Power cable adapter

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

SIIG SC-UNS012 Installationsanleitung Seite 4