SIIG Serial ATA PCI Installationsanleitung PDF herunterladen (Seite 12)

Windows XP (32-bit) / Server 2003 (32-bit)

For a New Windows XP / Server 2003 Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the Floppy folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft installation procedure to install

Windows accordingly.

3. Restart your system when prompted by Windows

installation.

4. At the Windows Setup screen, press F6 to install the

driver.

5. Insert the driver diskette. Press S then press Enter.

6. Select Silicon Image SiI 3x12 SATARaid Controller

for Windows XP/Server 2003/Vista and press Enter.

7. Press Enter to continue and follow on-screen

instructions to complete the installation.

When Windows installation completes, go to Installing

SATARaid GUI on page 20 and install the RAID utility.

For an Existing Windows XP / Server 2003 Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard.

For XP (w/SP1 or earlier)/Server 2003: Go to step #3.

For XP (w/SP2 or later)/Server 2003 (w/ SP1 or later):

Select No, not this time, then click Next.

3. Insert driver CD, select Install the software

automatically (Recommended), then click Next.

Note: Most systems will install the driver

automatically after inserting driver CD.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Keine Kommentare

SIIG Serial ATA PCI Installationsanleitung Seite 12