SIIG JU-SW4112 Installationsanleitung PDF herunterladen (Seite 4)

Windows Installation

Important: Do not connect the USB 2.0 Switch to your

system until after the driver has been installed. In order

for the driver to install properly the Power LED to that

system must be switched to another system. For example,

if you connect port A to system A, make sure the Power

LED on port A is not lit.

Windows 7 (32-/64-bit) / Windows Vista (32-/64-bit)

1. Insert the driver CD after Windows boots.

At the AutoPlay box: Click Run Setup.exe

If AutoPlay doesn't start: Click Start, in Start Search

type D:\Setup.exe, press Enter. (Change D: to

match your CD/DVD-ROM drive letter)

2. At User Account Control, click Allow.

3. Select your language, then click OK.

4. Click Next, Next, then Finish.

5. Plug the USB 2.0 Switch into an available USB port

(USB 2.0 recommended) with the supplied USB

cables and the driver will install automatically.

6. Press the Power LED/Manual switching button

that matches the system to complete the installation.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

SIIG JU-SW4112 Installationsanleitung Seite 4