SIIG SC-SAE311-S1 Installationsanleitung PDF herunterladen (Seite 12)

4. Insert the driver CD, check CD-ROM drives, uncheck

the other boxes, click Next, click Next again, then

click Finish.

5. Repeat steps 2-4.

6. Restart Windows to complete the installation.

When Windows resumes, go to SATARaid5 GUI on

page 16 and install the RAID utility.

32-bit Windows XP/Server 2003

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the 32bit folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Windows installation procedure.

3. At the Windows Setup screen, press F6 to install the

RAID driver.

4. When prompted, press S to specify the location of

the driver.

5. Insert the floppy disk, then press Enter.

6. Select Silicon Image SiI 3132 SoftRaid 5 Controller

for Windows XP/Server 2003, then press Enter.

7. Press Enter again to finish the driver installation,

then follow the on-screen instructions to complete

your Windows installation.

When Windows installation completes, go to SATARaid5

GUI on page 16 and install the RAID utility.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Keine Kommentare

SIIG SC-SAE311-S1 Installationsanleitung Seite 12