SIIG Low Profile PCI-2S Installationsanleitung PDF herunterladen (Seite 4)

4. From Choose Destination Location window, click Next.

5. Remove the Driver Installation diskette, select Yes to restart

Windows and click Finish.

To verify successful installation in Windows NT 4.0:

1. Go to Start / Setting / Control Panel, double click SIIG Cyber

PCI 20X device icon.

2. New COM port address number will be assigned for the ports

when successfully installed. The board is ready to connect

devices.

To change the I/O address in Windows NT 4.0:

1. Double click Start, Settings, Control Panel, then SIIG Cyber

PCI 20X device icon.

2. Highlight the COM address and click Settings.

3. Select or type in an I/O address supported by the device you

would like to configure and click OK. Make sure the selected

I/O address does not conflict with other device in your system.

4. Select Restart Now for the new setup to take effect.

Windows 2000:

1. At the New Hardware Wizard, click Next.

2. Select Search for a suitable driver for my device

(recommended) and click Next.

3. Select Specify a location, uncheck the other options and click

Next.

4. Insert the Driver Installation diskette, type in A:\Win2K and

click OK.

5. Click Next and Finish to complete driver installation.

To verify successful installation in Windows 2000:

1. Double click My Computer, Control Panel, System, Hardware,

and click Device Manager.

2. Click on the + (plus sign) in front of Ports (Com & LPT).

3. New Cyber port(s) should be listed.

1 2 3 4 5 6 7 8

Keine Kommentare

SIIG Low Profile PCI-2S Installationsanleitung Seite 4