SIIG CyberSerial ExpressCard Bedienungsanleitung PDF herunterladen (Seite 2)

Layout

Power

Connector*

Serial Port

(9-pin)

Jumper (J1)

Figure 1: DP CyberSerial PCIe Layout

* Note: If the serial port requires power output,

connect the system power source to board's power

connector. However, most serial devices do not

require additional power through the serial port.

Refer to your serial device's manual for more

information. Included is a "Y" split power adapter

cable, to use in case your power source doesn't have

the proper power connection.

Jumper Settings (J1)

Power output is from Pin 9 on the 9-pin serial port.

Short 2-3 or no jumper = 0 volts

Short 1-2 = 5V

Short 3-4 = 12V

Pin 9

1 2 3 4 5 6 7 8

Keine Kommentare

SIIG CyberSerial ExpressCard Bedienungsanleitung Seite 2