SIIG USB Over IP Installationsanleitung PDF herunterladen (Seite 13)

Configure the USB Over IP 1-Port

1. Right click on the listed Networking USB

Server 82E00C... and click Server

Configurations to change the default

settings, if needed. See Figure 8.

Note: If there's a device connected to the

USB Over IP 1-Port, make sure the

connection status is disconnected;

otherwise the configuration is not allowed.

Server Configurations

Figure 8

2. Change your Server Name, IP Address and

Subnet mask, if needed. Click Set after all

the changes are done. See Figure 9.

Note: Uncheck the Use DHCP box before

changing the settings.

1 2 ... 8 9 10 11 12 13 14 15 16

Keine Kommentare

SIIG USB Over IP Installationsanleitung Seite 13